ST2803W 28YRB / SIERA [TV]

• Tripping.
• No start-up. LED goes green, than switches back to red.
• Line output transistor fails repeatedly.
• No E/W correction.
• No or intermittent audio and picture.
• Pincushion distortion. on sides.
• TV doesn't quit standby. It makes 3 or 4 bips in the rhythm of green LED. Then LED goes to standby, becoming immovable and red.
• Reduced horizontal size. after a while.
• Trips.
• Switches to standby. after a few seconds.
• Picture appears slowly.
• Blank raster. Reduced horizontal deflection. Poor RC sensitivity.
• Blowing line output transistor, about every 14 days.
• Occasionally trips with a slight popping noise.
• No horizontal deflection. No tuning.
• White screen. Flyback lines.
• Stuck in standby.
• PSU pulsates. after a few seconds.
• Flashing horizontal lines on the picture.
• No audio (intermittently). No picture.
• No picture. intermittently.
• Burst of EHT then switches to standby. Standby LED flashes.
• Frame shrinks at bottom of screen after a certain time.
• Switches off by itself. after a few seconds. Red LED blinks.
• Excessive brightness. Flashing picture. (ST2803W SIERA repair tip)
• Line output transistor S/C.
• Picture dark with flyback lines on upper part, when cold (approx. 2 mins). (service info for SIERA -ST2803W)
• No function. Smell of burning.
• Picture flashes and cuts out. Comes back by itself intermittently.
• No start-up from standby when cold. LED changes from red to green then back to red when channel button pressed.
• Excessive horizontal size. E/W fault.
• Switches off by itself. at start-up.
• Enter service mode.
• Shuts down. LED flashes red and green.
• Shuts down after start-up. LED flashes red, then green.
• E/W fault.
• Switches to standby after approx. 45 mins. Can be restarted when cold (after approx. 5mins). Fails after a short time.
• Poor RC sensitivity.