 |
56KS3400 / SIERRA [TV 56 (52) cm picture]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for 56KS3400 / SIERRA.
List of fault symptoms:
- Teletext lines disappear (about 9 lines). (with circuit diagram extract)
- Frame rolls, jitters or picture unstable. (picture attached)
- IF information for stereo appliances, combi tuner and two-tuner appliances.
- For initial 10 minutes the picture is dark. (picture attached)
- Hum when volume off. Hum in low sound passages. (picture attached)
- Picture is crooked on either side (E/W). (picture attached)
- Tripping. intermittently. Pincushion distortion. on sides. (picture attached)
- Picture rolls in at the bottom. Vertical lienarity error.
- Jamming on vertical lines when switching set on in cold conditions. Visible with crosshatch pattern or with pattern lines.
- Other frame problems. (part of circuit diagram displayed)
- Excessive brightness. Flyback lines (intermittently). (extract of circuit diagram attached)
- Incorrect teletext character height.
- Safety test after repair.
- Automatic tuning does not stop when finding a station, although it scans bands ok. (picture attached)
- Poor or slow search.
- Excessive brightness. No picture. Retrace lines.
- No picture. after a while. Audio OK .
- Loss of tuning point after operating for some hours.
- No sound. Picture cramped by 5cm up and down.
- No picture. Audio OK . (picture attached)
- + 140 V present, no H.T.
- When changing to certain programmes the picture is not good at the beginning.
- Colour varies. (extract of circuit diagram attached)
- The picture turns blank, the sound sometimes disappears caused by TXT.
- No E/W correction. (picture attached)
- Frame synchronisation or synchronisation defects. (picture attached)
- When tuned in goes slightly off tune.
- Set dead, no 140V HT, 12V feed to the power supply is low.
- Distorted picture. (part of circuit diagram displayed) (56KS3400 tip from SIERRA)
- Dead. (+ extract of circuit diagram)
- Brightness fault. (extract of circuit diagram attached)
- Low picture amplitude. Approx. 3cm wide black edge on top and at the bottom.
- Picture tube A37-570X.
- Blurry picture. Audio OK .
- Will not lock onto station during sweep tuning. (extract of circuit diagram attached)
- Creaking.
- The picture briefly disappears.
- No RC functions (intermittently).
- Flashing picture. Picture too small.
- Increased picture width. Sideways distortions.
- Sync IC (TDA3571BQ) replaces IC TDA2571AQ.
- Picture is very dark, looks like a low voltage on CRT. (extract of circuit diagram attached)
- If appliance is cold it ticks; if it is warm, it runs ok; if power supply voltage is less than 220V, it ticks. (+ extract of circuit diagram)
- Connection of a loop system to the TV.
- Dead. Comes on in standby if switched on at mains plug and if made to come out of standby by pressing on/off switch the standby light goes off.
- Switches to standby.
- Insufficient brightness even if adjusting to maximum with RC.
- Resistor R303 (2.2 Ohm) blows continuously.
- No picture, no sound, high voltage and the display indication is present.
- Colour varies until black/white when the appliance is warm.
- After switching on approx 10-15 times the appliance cannot be switched on any more. Only the left volume balance light is still on. No picture and no sound.
- Height problems. (part of circuit diagram displayed)
- Fuse 2A on rectifier module goes defective after around 4-6 weeks. This always happens when switching on a VH appliance.
- After it has been switched on the TV switches off then switches on again, picture is faded (green). EHT discharge.
- Picture is cut off at the bottom and black bar.
- Vertical collapse. (part of circuit diagram displayed)
- No picture. (with circuit diagram extract)
- Intermittent colour. (extract of circuit diagram attached)
- LED display is distorted. No control.
- Intermittent low gain.
- V2000 loss of colour.
- Picture has strong "Moire" interference.
- Trapezoid picture.
- Dark screen, blank if brightness is increased. (SIERRA - 56KS3400 information)
- Flickering picture. (with circuit diagram extract) (56KS3400 tip from SIERRA)
- Too bright. Coloured flyback.
- Snow in picture.
- Continuously discharges between tripler and earth. (56KS3400 tip from SIERRA)
- Defective vertical deflection (oscillograms missing on the V deflection unit). Dark picture. (with circuit diagram extract) (service info for SIERRA -56KS3400)
- No vertical synchronisation.
- Constricted raster. (+ extract of circuit diagram)
- Set won't lock to channels in the search tuning mode, with no signal present. The line oscillator sounds way off frequency. (+ extract of circuit diagram)
- Line problems. (part of circuit diagram displayed)
- No picture, sound is present. Rastergrid lines present when switching off. (with circuit diagram extract)
- Defective vertical linearity.
- Distorted audio. (picture attached)
- Blank raster with bright, blurred flyback lines. (picture attached)
- Pal/secam transcoder.
- E/W fault. Excessive horizontal size.
- Went up in smoke.
- No vertical deflection. (extract of circuit diagram attached)
- Contrast problems. (+ extract of circuit diagram)
- Procedure to obtain a better sync.
- Reduced vertical size. (part of circuit diagram displayed)
- The TV does not switch on but fluctuates. (part of circuit diagram displayed)
- Lines in picture when using Japanese video appliances.
- When transmitting, a "second language" comes through. (extract of circuit diagram attached)
- Display initially shows 1, then E1 and E0 at switch on. Noise in picture and no control when EO in display.
- Store standard values.
- No channel search. Display OK .
- Dark picture.
- No functions. after start-up (intermittently). (part of circuit diagram displayed) (56KS3400 tips)
- Reduced vertical deflection.
- The appliance loses all the stored stations, works without the battery.
- With "scan" playback of VLU plates, rattle on appliances with mute switching. (with circuit diagram extract)
- The operation functions do not function The display functions.
- Blank raster. Searches for channels continuously.
- Clock problems.
- Line output transistor (BU208A) fails.
- The letters tip over during video text.
- Horizontal jitter.
- No TXT.
- Vertical lines.
- Memory loss in appliances with VST system.
- Picture like when there is loss of channel and recovery. No sound. (with circuit diagram extract)
- Processing of "non-standard" signals.
- Moire interference on channel S11 with K35 on S channels.
- Squealing noise. (extract of circuit diagram attached)
- Intermittently switches to STEREO or second language.
- Replacing prescaler module U18.
- Blank raster. Audio OK . (part of circuit diagram displayed)
- Distorted TXT reception (signal OK). TXT module used consists of U125 and U127 (thick film).
- On different channels the video tuner sound is missing. Sometimes the sound is present for a short time and then fails.
- Interference on channel 2 with TRD4 system.
- No switch from TXT mode to TV mode and TXT picture appears excessive. (+ extract of circuit diagram) (56KS3400 tips)
- No RC functions.
- No picture or audio. Blank raster. Everything is OK after warm-up.
- Sticks in stand-by. Appliance only starts up when plug V23 has been removed. No display.
- Picture shifted horizontally. (with circuit diagram extract)
- The picture is streaky and there is no UHF reception in high ranges.
- Service tips for Japanese VCRs.
- Replacement for U341 tuner.
- Electronic protection responds.
- Error codes. (extract of circuit diagram attached)
- No functions. No display.
- No reception during switch on.
- Mains switch and speech/music switch.
- Loss of display when switching over. Returns but disappears again after a few mins.
- Picture too small. (+ extract of circuit diagram)
- The picture pulls on the upper side of the picture. (part of circuit diagram displayed)
- No picture. No audio. Fault occurs intermittently. .
- No synchronisation on appliances with fitted TXT. (extract of circuit diagram attached)
- Extension print (SBC 312).
- Video is missing, small amount of chroma. (+ extract of circuit diagram)
- White screen. Flyback lines. Fault occurs intermittently. .
- The television gurgles. (extract of circuit diagram attached)
- E.h.t. leakage at the tube.
- When sweep tuning, station lock does not function. (part of circuit diagram displayed)
- Insufficient brightness when switching on. Shortly after, becomes brighter (looks like bad CRT).
- No picture, No sound. Picture is grey. Balance display on the left.
- + 12 V on pin 10 of U2 not present.
- Blank screen. High voltage and display OK. (SIERRA - 56KS3400 information)
- TXT reception problems with K30/K35 chassis. (picture attached)
- Hiccups from PSU when fluorescent light is switched on/off. (56KS3400 tip from SIERRA)
- Does not stop on K5 and/or K21 in search mode.
- Venetian blind effect. (picture attached)
- 2-3 flyback lines in top of picture. (part of circuit diagram displayed) (56KS3400 tips)
- Interference caused by rays from medium wave band transmitters. (extract of circuit diagram attached)
- Station search runs through stations, Stop command present.
- No contrast control.
- Print plate 256 divider U18.
- Change from TRD to TRD-ECO.
- On some channels when appliance is in mono it switches to stereo for a short time or audio channel 2 has a lot of audio interference. Repeats in irregular intervals.
- Faint flyback lines plus shading at one side. (56KS3400 tips)
- No start-up.
- No colour (intermittently). (+ extract of circuit diagram) (service info for SIERRA -56KS3400)
- No display.
- Line output transformer information.
- Horizontal lines run through the picture with playback of the VP 720 scart.
- Disconnection from the operating unit - chassis.
- Defective infra red control. (56KS3400 tips)
- E/W fault. (with circuit diagram extract)
- No tuning. (part of circuit diagram displayed)
- Horizontal lines in the picture and the colour sways.
- When tapped goes into standby. (picture attached)
- No start-up. intermittently.
- Smoke from air vents in back cover at switch on.
- During switch on the display does not work.
- Picture shadow a little to the right of the real picture. Visible before with test picture. Vertical raster lines cast a clear shadow on the left and right side of the circle, also with subtitling.
- Appliance switches off and back on when swift increase/decrease of voltage occurs.
- Horizontal shaking. after start-up.
- Teletext information moves.
- No channel storing.
- Does not change channels. No audio.
- Set intermittently goes off or into standby when lightly tapped anywhere.
- Memory loss. at switch-off.
- + 140 V not present. (service info for SIERRA -56KS3400)
- The TV switches on regularly after which the raster appears only with a snowy effect. On the screen there are also horizontal white bands. Tuning voltage is blocked.
- Slow warm up, first five to ten minutes picture dark with a restricted brightness control range. (with circuit diagram extract)
- Teletext faulty. replaced 2 text IC's now text on screen but picture still visible in background with grid effect.
- Protection circuit active (set hiccups).
- Replacement of tuner ECL2006 with UV418.
- Only snow in picture. After pressing cassette player channel no. appears but snow remains. Tuning voltage is 33V.
- After playing for some time, picture goes dark (2-3 times per evening).
- Zigzags. IC 3571BQ does not meet specifications. (part of circuit diagram displayed)
- Tuning drifting with horizontal white bars.
- The cable television picture rattles on several stations (during VHF or UHF or on both channels).
- Three types of line transformers.
- Faint flyback line. (+ extract of circuit diagram)
When SIERRA 56KS3400 fails , these symptoms are known and EURAS knows the remedy/solution.
Tips are coming from EURAS customers, workshops and payed technicians from all over the world. SIERRA 56KS3400 fails can be better solved. If SIERRA 56KS3400 fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when SIERRA 56KS3400 fails.
|
Additionally to repairtips or service information 56KS3400 is linked to 19 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into 56KS3400 ).
EURAS system also knows 612 appliances having the same chassis as 56KS3400 and can easily list them.
For 56KS3400 there are 7 compatible appliances known and can be listed.
In the repair discussion pinboard for 56KS3400 there are 5 replies to questions asked about 2 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for 56KS3400 from EURAS technicians or other users.
Do want to see this remedies/cures for repairtips? Register here for the EURAS System
Already registered? open 56KS3400 SIERRA in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
SIERRA
tech tips
(C) EURAS International Ltd.
Last updated: 29. Aug 2008 22:27:41 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All rights reserved, EURAS database V2.0 (C) 2002-2008.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|