F19 / TANDBERG [TV (chassis)]

• Pincushion distortion. Excessive horizontal size.
• No RC functions. after a while.
• High frequency whistle.
• Clicking noise.
• Volume display advances only approx. three quarters of its travel.
• Dim picture then a blank screen.
• Dead. No LED. (F19 tips)
• TR16 (S2055AF) goes s/c after replacement. (F19 TANDBERG repair tip)
• Line output transformer fails.
• Picture size varies.
• Dark picture. Low contrast. (service info for TANDBERG -F19)
• Switches off by itself.
• Stuck in standby. intermittently.
• Takes time raster to appear. No OSD. No tuning. No blue in picture with geometry errors via scart. (F19 tip from TANDBERG)
• Black screen. Audio OK .
• No picture. Audio OK. Flaring picture appears if G2 adjusted. (F19 TANDBERG repair tip)
• Erratic RC functions.
• No E/W correction. (F19 tips)
• Reduced horizontal size. No audio. No volume bar.
• E/W fault. Bowed edges.
• No functions. Switches to protection mode.
• Retrace lines. White screen. (F19 TANDBERG repair tip)
• Unable to turn sound up above level 4.
• Wavy picture on verticals.
• Stuck in standby. If attempting to start with RC, PSU whistles and goes back to standby.
• Black screen. on the left.
• No front control operation. When using RC channel change, but after a minute channel change by itself.
• No sound, just a crackle and buzz.
• Excessive horizontal size. (F19 tips)
• White screen. Audio OK .
• Picture yellow with tearing on left side of the screen.
• Unable to adjust audio volume. Volume bar stuck.
• Unable to alter sound. No sound menu available.
• E/W fault.
• No picture. Raster OK .
• Shuts down (intermittently).
• Switches to standby (after a while).
• Switches to standby.
• No start-up.
• Zooming from 4:3 mode to 16:9 mode depending on picture content. TXT OK.
• Dead. Standby LED flashes .
• Audio volume stuck. No tuning menu.
• Chopper FET S/C. (F19 TANDBERG repair tip)
• Picture size varies with picture content.
• Reduced horizontal size. Horizontal foldover. (TANDBERG - F19 information)
• Black screen. No audio. via tuner.
• Enter service mode.
• Line output transformer arcing.
• No sound and no picture via tuner. Sound OK via SCART. (F19 tips)
• Tripping.
• Picture dark or bright with flyback lines when turning up SG control. Sound ok.
• Stuck in standby. Clicking noise.
• After un difficult start up, appliance sizzles and switches back to standby.
• Sound is stuck at a very low level. Loss of horizontal synchronisation when switching over channels.
• No synchronisation. when changing channels. OSD and TXT OK .
• Dark picture.
• Switches to protection mode. intermittently (after warm-up).
• No start-up from standby with RC. (F19 TANDBERG repair tip)
• Audio does not increase above half level.
• Switches to standby. after start-up.
• Vertical bar. on the left.
• No picture. Flyback lines.
• Dead.
• Switches to standby (intermittently).
• No line and frame synchronisation with moiré at channel switch-over.
• Vertical foldover.
• No picture. Audio OK .
• Line output transistor is constantly S/C.
• Unable to enter service mode.
• Reduced horizontal size. E/W fault.