TT5001 / TANTEC [Sat receiver (analogue)]

• Dead.
• Tuning to incorrect station. (service info for TANTEC -TT5001)
• Main fuse blown.
• No radio channels or delayed reaction to buttons.
• MAC programmes numbers are not displayed. (TT5001 tip from TANTEC)
• Signal is missing, raster blank but LEDs lit.
• Black screen, no menu. Choosing menu may spark some reaction.
• Vertical channels are missing. (TT5001 TANTEC repair tip)
• MAC channels are missing.
• No audio. (TANTEC - TT5001 information)
• MAC channels are missing, MAC light is lit, PAL channels ok.
• Bars in picture.
• Picture is missing and when switched to standby the LED does not light up.
• Poor mac picture.
• Delayed reaction, poor MAC reception especially when set is cold.
• Stuck in standby.
• Missing horizontal reception on voltage controlled polarisation.
• Wandering stripes in picture, like interference. (TT5001 tip from TANTEC)
• Horizontal bar on MAC picture; intermittently divides into 4-5 horizontal bars. PAL OK.
• Not tuning in mac decoded broadcasts. PAL OK.
• No MAC decoder function.
• LNB supply is too low.
• "No access" message on screen in some channels.
• Setting factory default.
• Remote and manual controls are slow to respond.
• Appliance is dead, LEDs lit.
• Vertical polarity is missing.
• Horizontal channels are missing.
• Text goes on unprompted.