EURAS System
   EURAS worldwideeuras.com    
EURAS System

TM4230TNLD / TARGA [Monitors]

The EURAS repair tip database for professional technicians and service engineers supplies the following faults for TM4230TNLD / TARGA.

List of fault symptoms:
  • No picture.
  • No red (signal is distorted).
  • Picture compressed vertically, excessive flickering. Vertical picture shaking. Linearity distortion. Black/white stripes in the picture.
  • Brightness adjustment.
  • Raster (white balance) adjustment.
  • E/W fault.
  • Setting of sub phase.
  • Shadow in the picture. One colour missing.
  • Tilt, H-centre, H-size, V-position, V-size and V-linearity adjustment.
  • No red.
  • Red flags in the picture.
  • Picture position cannot be adjusted horizontally and vertically, swims a bit to the right and left then jumps back again. Occasionally does not synchronize.
  • No horizontal synchronisation with > 640x800.
  • High voltage regulation.
  • Blue flags.
  • Horizontal and vertical tearing in the whole picture.
  • Focus regulation adjustment.
  • E/W and trapezium cannot be adjusted. (service info for TARGA -TM4230TNLD)
  • Type of transistor Q903. (TARGA - TM4230TNLD information)
  • Picture is dark. Deflection goes, H deflection varies the frequency by quite a few KHZ.
  • Shadowy picture on the right and left of the picture , like a stripe at the edge of the picture.
  • Gain (white balance) adjustment.
  • Noises with bright pictures and then stripes in the picture (horizontal every 0.5-1cm).
  • No picture and no sync. (TARGA - TM4230TNLD information)
  • Sparks at tube base.
  • ABL
  • High voltage switches off, esp. when appliance is cold.
  • Line transformer is defective.
  • Red flags in the picture.
  • CG regulation adjustment.
  • Specifications.
  • E/W fault. Pin and trapezium cannot be adjusted.
  • No LCD display/no user control.
  • One colour ist missing. 3 vertical lines of that colour on the left hand side of the picture.
  • Out of focus, cannot be adjusted sufficiently.
  • Picture width only approx. 5-10cm. (service info for TARGA -TM4230TNLD)

With this service information, you may repair TARGA TM4230TNLD faster/better when it fails.

When TARGA TM4230TNLD fails , these symptoms are known and EURAS knows the remedy/solution.

Tips are coming from EURAS customers, workshops and payed technicians from all over the world. TARGA TM4230TNLD fails can be better solved.

If TARGA TM4230TNLD fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register.

With help of this list a solution is found often when TARGA TM4230TNLD fails.


Additionally to repairtips or service information TM4230TNLD is linked to 20 components (IC's and/or transformers) in the Tectra database, through which you can identify electrical compatibilities (crossreferences) in appliances.


For TM4230TNLD there are 3 compatible appliances known and can be listed.


Do want to see this remedies/cures for repairtips?   Register here for the EURAS System

Already registered? open TM4230TNLD TARGA in EURAS

All details on the EURAS System: English | Deutsch | Français | Italiano | Español | Magyarul | Português | Polski | Română | Greek |


Back to EURAS Homepage >> All manufacturers >> TARGA tech tips  


(C) EURAS International Ltd.










Last updated: 29. Aug 2008 20:13:13 MET, doccode ISO9002AS168EKA200805C EURASMOP

Responsible for the content: EURAS International GmbH, Eime, Germany. All rights reserved, EURAS database V2.0 (C) 2002-2008. All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.