14D962 / TASHIKO [TV]

• No signals and only channels 3 and 4 can be selected (14D962 tip from TASHIKO)
• Line output transistor does not function. (service info for TASHIKO -14D962)
• Corrugated verticals.
• Intermittent colour drop out (of one colour).
• Bright raster with flyback lines.
• No functions (intermittently).
• Vertical elements of picture are sawtooth in shape. (14D962 tip from TASHIKO)
• Low frame scan.
• Takes long time to warm up picture fuzzy.
• Intermittently appliance breaks down.
• When first switched on there's no picture just snow. A normal/quality picture may appear after a while, but when the set is switched off then on again the fault symptoms are repeated.
• Poor picture until warm.
• Poor synchronisation.
• Partial field collapse, no sound and shaky picture.
• When appliance is first switched on the picture is snowy.
• Line pulling at top of picture on video playback.
• Dead. Power start up.
• Snowy raster on switch on from cold, picture appears after 1 min.
• Low brightness in PIP function and also TXT mode.
• The picture breaks down, not enough field scanning. (service info for TASHIKO -14D962)
• After approx one hour, patterning and insufficient height.
• No horizontal drive.
• Ragged verticals varying with picture content.
• Corrupt text in TXT.
• Line pulling and buzzing noise when cold.
• Bright picture with flyback lines.
• Appliance trips quickly.
• Intermittent snowy picture (looks as if no aerial connected). No operating functions.
• Text corruption.
• Dead. Whistling sound.
• At switch on picture has lines across with buzzing noise.
• Volume increments to large.
• On channel 41 onwards, there are fine horizontal bars.
• The lines are drawn out on the top part of the picture during video PB.
• Intermittent loss or predominance of one of the three primary colours.
• Interference lines on picture for first 2-3 mins. Black lines across screen, line pulling.
• Frame collapse/low field scan.
• PIP defective or missing.
• Buzzing sound from PSU, especially from cold.
• No signals & only channels 3 & 4 can be selected for the first 10 mins.
• Line twitching.
• PIP becomes negative intermittently with a bizarre overload effect.
• Sync is very defective. (14D962 tip from TASHIKO)
• Picture is lost a short time after switch on.
• Thin horizontal bars on channels 41 and above.
• Stuck in standby or front functions will not operate.
• Insufficient height with noisy signal.
• Buzzing noise and line pulling when cold.
• Reduced vertical size.
• Bar graphics for volume etc. do not work.
• Intermittently powers down.
• Insufficient height. Poor linearity.
• No start-up.
• No signal.
• Does not memorize stations.
• Unstable picture plus patterning.
• Intermittent dead set (no horizontal output).
• Intermittent tuning, just noise.
• Lines at top of picture. Bright foldover.
• Stuck in standby.
• There was a good picture when first switched on, but when the brightness was increased there was line tearing across the screen.
• Erratic line sync in TXT mode.
• Text fails.
• Arcing sound at switch on. (TASHIKO - 14D962 information)
• Intermittently dead. (14D962 TASHIKO repair tip)
• Switches off intermittently (stops working) or does not start up.
• PSU pulsing.
• No picture.
• Slow sound/picture, channel change and tuning.
• Corrupted text.
• Snow on screen for first 10 minutes.
• No manual controls. RC OK.
• Dead. Remains in standby.
• No picture. No audio.
• Defective picture until appliance warms up. (14D962 tips)
• Height is reduced and corrugated verticals.
• Excessive brightness with flyback lines.
• Dead after a few hours.
• AFC lockout on some channels. (14D962 tips)
• Vertical picture foldover. Lack of width. Occurs when warm.
• Field jitter and/or partial field collapse.
• Interference lines on picture.
• Patterning. Insufficient height when hot.
• Vertical collapse (intermittently).
• Noise in picture and/or lack of height.
• At switch on picture breaks up into horizontal lines with bad twitching. The sound buzzes and pops.
• Picture becomes poor when brightness is turned up.
• Noisy picture with slight lack of height.
• Pattern on screen after one hour.
• Line interference in picture. (service info for TASHIKO -14D962)
• Line speed break up.
• Insufficient height and linearity after changing TDA4505.
• Poor frame scanning, the significance of which depends on the picture content.
• Interference of fine horizontal lines. Occurs in high channels of UHF band. (14D962 tips)
• Partial frame collapse, no sound and a shaky picture.
• When switching to TXT mode video signal is not being blanked out and no TXT info is shown.
• Can't display some prerecorded tapes.
• Lack of width. Picture foldover vertically. Occurs when warm.
• Red picture intermittently.
• No picture. Noise only.
• Blurry picture.
• No sound or picture, weak output power from PSU.
• When cold, signal is missing and width is reduced.
• The picture breaks down.
• Dead.
• Picture collapses after approx 1 hour.
• During bright scenes or when brightness is turned up, there is line tearing.
• Insufficient height. Patterning at first, maybe squeals.
• Intermittent teletext. (14D962 tips)
• No picture, just snow at first.
• Noisy signals and Insufficient height.
• Picture comes on too bright when brightness adjusted.
• Flashing lines across picture. Arcing noise when cold.
• The height is reduced which leads to complete picture loss.
• Will not come on for the first 15 mins, then snowy picture and sluggish channel change
• Slow to produce audio/visual channel change and tuning.
• Intermittent shut down after approx. ten minutes.
• No programme indication at switch on.
• No horizontal drive.
• TXT cuts out.
• Does not lock onto station in automatic tuning mode. (14D962 TASHIKO repair tip)
• Faint swirling pattern in the background on dark scenes.
• Dead or intermittently dead. (14D962 TASHIKO repair tip)
• Intermittent picture. Fades.
• Poor picture when brightness increased.
• Arcing noise and flashing picture for first 10 mins or line tearing on high brightness scenes.
• Intermittent snowy picture (like when there is no aerial). No operating functions.
• Tuning goes out, goes into standby, poor channel selection.
• No RC functions.
• Snowy picture. Pops at switch on. (14D962 tip from TASHIKO)
• Will lace up and then immediately unlace.
• When switched on from cold set arcs. (14D962 tips)
• Poor picture scanning.