VVE182 / TASHIKO [Video recorder]

• Dead.
• Laces up then stops.
• Erratic audio erase and record.
• Any one or more incorrect or missing transport function, loads ok.
• Intermittent sound and picture signal output from tuner.
• Hum bar during E-E and PB.
• Assembly mode info.
• Play or record are interrupted randomly and appliance returns to stop mode.
• Does not PB sound but REC it correctly. (TASHIKO - VVE182 information)
• No colour REC.
• E-E problems.
• Appliance loads but no functions possible. (service info for TASHIKO -VVE182)
• FF and PAUSE do not function correctly.
• At switch on rewinds until off is pressed. Display indicates a cassette is inserted when it is not. Cassette not loaded but if a cassette is inserted manually it functions in Play, REW, FF etc and also ejects.
• Drum servo is not positioned correctly, lines in the picture. (service info for TASHIKO -VVE182)
• During PLAY appliance switches to REW.
• When warm the drum speed alters.
• No functions.
• No display.
• Incorrect capstan and/or reel motor speeds.
• Intermittent deck functions.
• No tape end stop.
• Appliance functions erratically.
• Display is missing plus possible incorrect mechanical function.
• Fails to play or record intermittently.
• Laces but the drum does not rotate.
• Playback picture is poor or intermittent.
• Picture rolls or shudders.
• Intermittent squealing noise from loading belt.
• PB and E-E picture distorted and jumping.
• Intermittent stops on record/play.
• PDC display flickers with slight distortion in the aerial signal.
• In LP one channel is missing. (VVE182 TASHIKO repair tip)
• PLAY during LP or LP and SP is poor.
• According to display and monitor, channels are tuned in and stored but by changing the channel storage, data is not stored and the system reverts to channel 21.
• In the E-E and playback modes a single, large hum bar travels from the bottom to the top of the display on the monitor's screen.
• Will not tune or change channels. The channel No. display permanently shows just two horizontal lines. Segments "G" and "G" only illuminated.
• No sound on E/E.
• Cannot change channels.
• Cassette is not ejected, or loading/unloading incorrect.
• Vertical collapse.
• The appliance does not eject, squealing noise from loading belt and then the appliance shuts down.
• No record LP, SP OK.
• Capstan lock is missing or intermittent.
• No FF. No REW.
• No function, no clock. (VVE182 tip from TASHIKO)
• No tuning starting from channel 50. OK with lower channels.
• No PB.
• Cannot load.
• Back display is faintly lit with unwanted segments.
• When switched on functions do not operate, squeals then goes to standby.
• Clock loses time.
• Tuning and clock set-up do not function.
• Mechanical noise when ejecting tape.
• Looks as though heads have gone.
• Intermittently cannot change channels. (VVE182 tips)
• No capstan rotation.
• Capstan motor is free running. Locks only occasionally when appliance has warmed up.
• Search tuning does not stop when station is found.
• Only E-E sound.
• Noise on picture.