 |
CTW3250S1 / TEAC [TV 16:9 from 82 (76)cm picture]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for CTW3250S1 / TEAC.
List of fault symptoms:
- Switches to standby (after start-up).
- E/W fault.
- Standby PSU is defective.
- No start up. PSU ticks. LED switches every second. Switches on and off.
- Brightness varies. No RC functions. intermittently. Shuts down. intermittently.
- Beeps shortly at start-up, then no function. LED dead.
- No start-up (when cold).
- PSU whistles at switch on. No other functions.
- Comes out of standby with green LED on and after 5 secs switches to standby with red LED on.
- Vertical jitter. (CTW3250S1 tip from TEAC)
- No picture. Audio OK .
- Q602 fails repeatedly.
- Excessive horizontal size. E/W fault.
- Reduced vertical size.
- No functions.
- No start-up. Red LED blinks.
- Tripping. LED blinks .
- LED is green for a short time and then switches off.
- Poor picture. Low brightness. Low contrast.
- Flyback lines. Coloured lines. at top. (service info for TEAC -CTW3250S1)
- Switches to standby. No picture.
- PSU blow-up. (service info for TEAC -CTW3250S1)
- Switches to standby after start-up. EHT rustle.
- No RC functions.
- Low HT intermittently, followed by tripping.
- Switches to standby.
- No start-up.
- Tripping. after start-up. Red LED blinks.
- No vertical synchronisation.
- No picture. Black screen.
- Coloured lines when changing channels. Incorrect geometry.
- Dead.
- Tripping.
- Transistor BU2508AF fails after 1 min. (CTW3250S1 tips)
- Stuck in standby. LED blinks .
- Frame output IC600 fails repeatedly.
- Ticking noise. LED blinks .
- Pincushion distortion. Excessive horizontal size. (CTW3250S1 tip from TEAC)
- L601 overheats.
- Electrolytic capacitor C116 becomes hot and defective. (TEAC - CTW3250S1 information)
- Intermittent start-up. Ticking noise in standby. LED is green then red.
- No picture or just a vertical line.
- Shuts down.
- No vertical deflection.
- No start-up from standby.
- Line output transistor S/C at start-up.
- Trips. Standby LED does not light. (CTW3250S1 tip from TEAC)
- PSU ticking.
- Q100 and Q102 fail repeatedly.
- Reduced horizontal size (at start-up). Excessive horizontal size (after warm-up).
- Switches to protection mode.
- Interference in picture.
- No start-up. Standby LED is red. Green light shows briefly then switches to standby when switching.
- Switches intermittently to standby. Ok in test mode.
- Shuts down. after start-up.
- PSU tripping loudly.
- Distorted E/W. Low height. Picture has shifted downwards.
- Wite bright lines on upper picture edge. (CTW3250S1 tip from TEAC)
- Enter service mode.
- Noise from SMPS while in standby. (CTW3250S1 TEAC repair tip)
- Dead. intermittently.
- Horizontal roll.
- No vertical deflection (intermittently).
- No picture. No audio.
- Horizontal output transistor fails repeatedly.
- No horizontal synchronisation.
Tips are coming from EURAS customers, workshops and payed technicians from all over the world. TEAC CTW3250S1 fails can be better solved. If TEAC CTW3250S1 fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when TEAC CTW3250S1 fails.
|
Additionally to repairtips or service information CTW3250S1 is linked to 62 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into CTW3250S1 ).
EURAS system also knows 53 appliances having the same chassis as CTW3250S1 and can easily list them.
In the repair discussion pinboard for CTW3250S1 there are 87 replies to questions asked about 45 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for CTW3250S1 from EURAS technicians or other users.
Do you want to see this remedies/cures for repairtips? Register here for the EURAS System Please note: access to the EURAS System can be granted only to professional
TV/Video/household electronics repair shops/technicians which are
authorized for service by a manufacturer, or can prove to be professionally
certified to do repairs on electronic appliances. You will be asked for a
statement and information accordingly during registration.
If you do not qualify as stated above and you have an appliance that needs
technical service, we do recommend you to contact the manufacturer (for
example through his website) or go to a professional TV/Video/household
electronics repair shop close to you.
Already registered? open CTW3250S1 TEAC in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
TEAC
tech tips
Last updated: 14. Oct 2008 06:46:33 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|