EU2845ST / TEAC [TV 16:9 70 (66) cm picture]

• No vertical deflection. on lower half screen.
• Picture shifted vertically.
• Picture jitters. TXT OK . (EU2845ST TEAC repair tip)
• Standby LED is red then turns to green at switch on. HV appears then switches to standby. Cycles on/off.
• Excessive horizontal size.
• Cycling on/off. LED lit red then green.
• Red tinge in picture.
• No start-up from standby.
• Vertical collapse. (service info for TEAC -EU2845ST)
• Cycles on/off.
• Low supply voltages at secondary PSU.
• Switches to standby. after a while.
• White screen. Flyback lines.
• No picture. Sound OK. Stripe or half picture visible.
• No picture. Blank raster. (EU2845ST TEAC repair tip)
• No start-up from standby, intermittently. Picture blanking out when picture size selected. Shuts down intermittently.
• Values of R611 and R614 resistors.
• Picture too big. Pincushion distortion. on sides.
• Trips. after a few seconds.
• Poor geometry. Sloping picture from left to right. Trips if adjustment value is greater than 17.
• Reduced vertical size at top.
• Vertical collapse. Audio OK . Shuts down.
• LED changes red/green every 5 sec. Sound crackles.
• Brightness varies. intermittently.
• Vertical foldover at top and bottom.
• Cycles on/off. OK after a while .
• Value of R603.
• Shuts down when is switched to 4:3 mode.
• Changes channels down by itself after a few hours.
• Picture slightly tilted with a black band angled on the right.
• No operation.
• Cycles on/off. LEDs flashing at start-up.
• Stuck in standby.
• Picture blanking in some modes.
• Dull picture flashes at switch on then switches to standby. LED changes from green to red.
• LED blinks green then red constantly.
• No start-up. Plopping noise from PSU.
• Picture zoom fault.
• Excessive vertical size. Bottom half of picture is not visible. Pincushion distortion on the left.
• Shuts down (after start-up).
• Switches to standby. after a few seconds.
• No OSD. (TEAC - EU2845ST information)
• No picture.
• Enter service mode.
• Picture shifted vertically. at top.
• Half picture, flyback lines above and poor E/W.
• Gemoetry faults. Excessive horizontal size.
• Reduced vertical deflection.
• Cycles on/off rapidly with clicking sound and red LED flashing.
• Low voltage on 33V line.
• Sky remote code.
• No picture. Audio OK .
• Picture shifted vertically. at bottom. Pincushion distortion.
• Reduced vertical size.
• Vertical cramp at bottom. Horizontal lines at bottom.
• No function. The PSU oscillates and goes off after 2 seconds.
• Dead.
• Tripping.
• Reduced vertical and horizontal size.
• No audio. No picture. LED blinks .
• Blank raster. Audio OK .
• Defective vertical deflection.
• Faulty geometry settings. (EU2845ST tips)
• Stereo signal fails with contrast rich pictures. Green LED (Stereo indicator) flashes with brighter pictures.
• No picture. Vertical collapse. at switch-off.
• No start-up intermittently. LED flashes when cold. Buzz from speaker intermittently. (EU2845ST tip from TEAC)
• Switches to standby.
• Cross modulation. Corrugated verticals.
• Tripping. Raster OK .
• Shuts down when switched to AV.
• Shuts down. after a while.
• Spots in picture.
• No start-up, only standby. HV pulsing.
• Flyback lines. at top. Blank raster. at bottom.
• Poor picture. Lines in picture. via tuner. OK via SCART .
• No RC functions. intermittently.
• No start-up. Tripping. (EU2845ST tip from TEAC)
• E/W fault.
• Occasionally no picture and no sound in the short term. Fault occurs only 2-3 times approx 2 mins after switch on. Also via the scart socket. (TEAC - EU2845ST information)
• No picture. at bottom.