 |
EU3242ST / TEAC [TV 16:9 from 82 (76)cm picture]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for EU3242ST / TEAC.
List of fault symptoms:
- No start-up.
- Reduced vertical size at top.
- Does not switches to AV, switches to standby from AV mode.
- Picture is too big vertically and in E/W in 4/3. OK in 16/9. (EU3242ST tip from TEAC)
- R613 runs hot.
- Vertical fault. Blank picture in 4:3 mode.
- Tripping.
- R603 (0.47R) fails repeatedly. (service info for TEAC -EU3242ST)
- Reduced horizontal deflection.
- Switches to protection mode.
- Half a picture.
- TXT shifted to the left.
- Vertical collapse. Switches to standby.
- Hiss in audio.
- Excessive horizontal size. Pincushion distortion.
- Switches to standby.
- Tuning fault.
- No picture. Tuning OK .
- Shuts down after start-up. LED changes from red to green. (EU3242ST TEAC repair tip)
- No start-up from standby.
- LED changes red/green every 5 secs. Sound crackles.
- Trips when changed from 16:9 to 4:3.
- No audio and picture intermittently on digital reception. Cuts out intermittently.
- Switches after a few seconds to standby. LED changes from green to red.
- Blank raster. Flyback lines. Audio OK .
- Power supply hiccups.
- Switches off by itself. after a few minutes.
- No synchronisation using VCR.
- Shuts down after a few seconds. Audio and picture OK. Need to unplug appliance to start again.
- Switches to standby. after a few seconds.
- Reduced horizontal size.
- Low brightness. Low contrast. at start-up. OK after a while .
- Flashing picture.
- Popping sound from speakers in standby. Popping sound disappears when switching. After a few attempts of start-up popping sound returns.
- Comes on with green LED then switches to standby.
- Rolling picture via AV1.
- Vertical foldover at top in certain modes. Switches to standby.
- No power.
- No power on AC.
- Shuts down. after start-up.
- Vertical foldover. at bottom.
- Trapezium fault.
- Raster appears then shuts down. LED switches from red to green.
- No picture. intermittently.
- Lines in picture.
- No picture.
- No picture. Audio OK .
- No raster. Green LED at switch ON.
- Stuck in standby.
- Vertical foldover at top. Switches to standby. after start-up.
- Fusible resistor R603 O/C.
- Install menu appears. Intermittently blue picture. No signal.
- E/W fault.
- Enter service mode. (EU3242ST tips)
- Mains fuse and FET Q102 blown.
- Dead.
- Horizontal foldover.
- Geometry fault.
- Excessive horizontal size. E/W fault.
- No picture in 4:3 mode. (service info for TEAC -EU3242ST)
- Pincushion distortion. on sides. Excessive horizontal size. Excessive vertical size.
- Starts up, works briefly then goes to standby. From then onwards it starts up spontaneously. Vertical foldover at the top of picture.
- No output from PSU. Ticking noise.
If TEAC EU3242ST fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when TEAC EU3242ST fails.
|
Additionally to repairtips or service information EU3242ST is linked to 37 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
Chassis information is available (which chassis is built in into EU3242ST ).
EURAS system also knows 49 appliances having the same chassis as EU3242ST and can easily list them.
In the repair discussion pinboard for EU3242ST there are 136 replies to questions asked about 117 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for EU3242ST from EURAS technicians or other users.
Do you want to see this remedies/cures for repairtips? Register here for the EURAS System Please note: access to the EURAS System can be granted only to professional
TV/Video/household electronics repair shops/technicians which are
authorized for service by a manufacturer, or can prove to be professionally
certified to do repairs on electronic appliances. You will be asked for a
statement and information accordingly during registration.
If you do not qualify as stated above and you have an appliance that needs
technical service, we do recommend you to contact the manufacturer (for
example through his website) or go to a professional TV/Video/household
electronics repair shop close to you.
Already registered? open EU3242ST TEAC in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
TEAC
tech tips
Last updated: 07. Oct 2008 18:10:35 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|