 |
11AK195 / TECHLINE [TV (chassis)]
The EURAS repair tip database for professional technicians and service engineers
supplies the following faults for 11AK195 / TECHLINE.
List of fault symptoms:
- At start-up LED switches to green then goes to standby and LED blinks red.
- Arcing HV.
- Electrostatic discharges audible in speakers.
- Raster appears in forms of horizontal bars.
- HV flashover at FBT TR602.
- No TXT after operating time. Appliance switches to TXT, only shows 100 top left. Below coloured bars are visible. When appliance is cold TXT functions perfectly.
- No vertical deflection.
- Blank screen.
- No OSD.
- No horizontal deflection.
- Noise from speakers in standby. Oscillating noise in audio.
- No RC functions.
- TXT fault.
- Blank picture. Coloured lines at top.
- Blank picture. Flyback lines.
- E/W fault. Excessive horizontal size.
- Vertical roll.
- Video output IC901 (TDA6107Q) burns after a few days. (11AK195 tip from TECHLINE)
- Spot in the centre of screen.
- No start-up. Power LED lit for a second then disappears.
- Dead. Standby LED lit .
- No start-up.
- Dead. LED blinks .
- Enter service mode.
- No audio in SECAM L MONO.
- Switches to standby. after start-up.
- Annoying noise from PSU. Functions OK.
- No picture. Flyback lines. Audio OK .
- Line output transistor fails repeatedly. after a few minutes.
- Vertical foldover.
- No screen adjustment.
- No colour. (11AK195 TECHLINE repair tip)
- No start-up. intermittently.
- Vertical size varies.
- PSU pulsates. No start-up from standby.
- Low contrast.
- Noise from speakers, in standby. (11AK195 tip from TECHLINE)
- No video signal via SCART.
- Noise from speakers in standby.
- No E/W correction.
- Stuck in standby. LED flashes 2 times at start-up.
- Slow start-up. Pulsating picture appears then switches off.
- Ticking noise. in standby.
- Audio output IC100 (TDA2614) burns.
- No channels.
- Dead.
- Blank picture. White stripe at top of screen. (TECHLINE - 11AK195 information)
- No tuning.
- No audio.
- Snow in picture.
- No TXT.
- Horizontal foldover.
- Picture size varies with brightness.
- No start-up. Green LED flashes .
- Blank screen.
- Dark picture.
- Excessive brightness. Flyback lines.
- Millky picture. Raster OK.
- Switches to standby. after start-up. Red LED blinks.
- Faulty OSD.
- Blue picture in SECAM.
- Switches off by itself. in standby (intermittently).
- White screen. Flyback lines.
- No raster.
- No audio in NICAM.
- No picture in PIP mode.
- Annoying noise in standby.
- Bright picture.
- Reduced vertical and horizontal size. intermittently.
- Low audio in MONO.
- Line output voltage at 60V approx.
- No start-up. Green LED flashes .
- Shuts down. after start-up.
- Reduced horizontal size. (TECHLINE - 11AK195 information)
- Line output transistor fails repeatedly.
- Vertical line tearing.
- Interference in picture from lower channels.
- Black screen. (11AK195 tips)
- LED briefly green and goes to standby again.
- No start-up from standby with RC.
- Switches to standby when started with RC. (service info for TECHLINE -11AK195)
If TECHLINE 11AK195 fails, this information will help you. Here you can only see the symptom list, to access remedies, you must register. With help of this list a solution is found often when TECHLINE 11AK195 fails.
|
Additionally to repairtips or service information 11AK195 is linked to 29 components (IC's and/or transformers) in the Tectra
database, through which you can identify electrical compatibilities (crossreferences) in
appliances.
|
For 11AK195 there are 12 compatible appliances known and can be listed.
In the repair discussion pinboard for 11AK195 there are 25 replies to questions asked about 13 different repair problems. With access to EURAS you can all read them or enter your own questions and get help for 11AK195 from EURAS technicians or other users.
You can display a list with all appliances that have build in the 11AK195/TECHLINE chassis.
Do you want to see this remedies/cures for repairtips? Register here for the EURAS System Please note: access to the EURAS System can be granted only to professional
technicians/Video/household electronics repair shops/TV which are
authorized for service by a manufacturer, or can prove to be professionally
certified to do repairs on electronic appliances. You will be asked for a
statement and information accordingly during registration.
If you do not qualify as stated above and you have an appliance that needs
technical service, we do recommend you to contact the manufacturer (for
example through his website) or go to a professional household/Video/TV
electronics repair shop close to you.
Already registered? open 11AK195 TECHLINE in EURAS
All details on the EURAS System: English |
Deutsch |
Français |
Italiano |
Español |
Magyarul |
Português |
Polski |
Română |
Greek |
Back to EURAS Homepage >>
All manufacturers >>
TECHLINE
tech tips
Last updated: 15. Oct 2008 22:27:06 MET, doccode ISO9002AS168EKA200805C EURASMOP
Responsible for the content: EURAS International GmbH, Eime, Germany.
All brand- or productnames are copyrighted by the respective manufacturer of the appliance and are only being used for identification purposes.
|
|