VHS360POS / VIDEOTRONIC [TV/video/DVD combination]

• Does not accept cassette, after being turned on lacing motor runs back and forth and appliance does not stop.
• SECAM chroma bandpass alignment. (+ extract of circuit diagram) (VIDEOTRONIC - VHS360POS information)
• Tape is not unlaced.
• Loud noises during rewind. (VHS360POS tip from VIDEOTRONIC)
• No play, forward or rewind. After a short time the appliance switches off. Eject does not work.
• Tape mechanism doesn't function. Display ok, but no function.
• Shut down circuit adjustment.
• Will not switch on, if you insert a cassette, appliance goes to Power ON and then to PLAY. Otherwise does not accept any functions. (VIDEOTRONIC - VHS360POS information)
• The reel motors run continuously. (picture attached)
• Bold interference lines in the picture. The the right guide bolt does not completely load the tape.
• Vertical size adjustment.
• No drive function. (+ extract of circuit diagram)
• Poor torque from reel motor.
• Tape guide is difficult to adjust.
• Does not accept tape. (extract of circuit diagram attached)
• The lower edge of the tape becomes damaged. (VIDEOTRONIC - VHS360POS information)
• Capstan motor doesn't function.
• In Play VCR laces in halfway and then immediately unlaces again. Head drum does not run. (picture attached) (VIDEOTRONIC - VHS360POS information)
• Black and white tracking adjustment.
• No function at times.
• Switches off in Play after a few secs. Tape is not transported although capstan motor runs.
• SECAM identification adjustment. (picture attached)
• Capstan does not rotate and head drum rotates freely.
• Static convergence adjustment.
• Dynamic convergence adjustment. (+ extract of circuit diagram)
• Appliance loads then immediately unloads. Appliance remains on. (part of circuit diagram displayed) (VHS360POS tip from VIDEOTRONIC)
• All functions OK except play.
• SECAM phase and B-Y, R-Y level adjustment. (picture attached)
• The video head runs continuously. (picture attached)
• After being switched on the lacing motor does not run to its correct position and the appliance switches off. (with circuit diagram extract)
• Does not eject cassette. Appliance switches off after a short time.
• The cylinder does not turn. (+ extract of circuit diagram)
• APC adjustment.
• No switch on. When cassette inserted, appliance switches on in PB. No further functions.
• Drive mechanism has no functions.
• Audio PB level adjustment.
• Focus adjustment.
• Only laces in half way.
• The end loading procedure is not recognised; the reel-table motor, the capstan motor and the head drum stop turning after 3 to 4 seconds.
• Main board adjustment point location. (extract of circuit diagram attached)
• Major components location guide. (picture attached)
• Appliance laces up half way and immediately out again. Display shows fast forward and rewind but no function. (extract of circuit diagram attached)
• P G shifter adjustment. (part of circuit diagram displayed)
• Tracking fix adjustment. (picture attached)
• The video head runs too fast. (part of circuit diagram displayed)
• No drive function possible.
• Appliance runs to fast in play. (extract of circuit diagram attached)
• No PB. Cassette is accepted, briefly switches to FF and REW, then switches off.
• Appliance carries out all functions except Play. (+ extract of circuit diagram)
• Sub h-hold and h-hold adjustment.
• Cassette is loaded. No further functions.
• Hue delay adjustment.
• 103VDC adjustment.
• Appliance unlaces in play mode after approx 15 mins and switches to REW. Then for a short time switches to FF. Drive keys are blocked from then. Eject no longer functions. (picture attached)
• During play the appliance does not lace up completely and then switches off.