WD36SB / WINDSOR [TV 36/37 (34-36) cm picture]

• Picture folds down at the bottom. Linearity and vertical position cannot be adjusted.
• Switches to protection mode. (service info for WINDSOR -WD36SB)
• Strong continuous chirp from mains transformer with normal operation. Horizontal interference lines (pinch).
• PSU pulsates quickly at switch on.
• Switches to standby (after warm-up).
• Key-LED lights green for a short time, then becomes red.
• Squealing noise. at start-up.
• No start-up.
• Vertical deflection reduced to 2-4 cm.
• Dark picture.
• BU808DFI fails every so often.
• Blue screen. Flyback lines.
• TV does not switch on. Standby LED flickers.
• No start-up. Display flashes .
• Stuck in standby.
• No picture. Audio OK .
• No colour.
• Line output transistor faulty.
• Vertical lines. Unstable picture.
• No HV.
• No picture. Blank raster. Audio OK .
• Dark stripes in picture after a few minutes. Growing thicker and distorting the picture. (WD36SB tip from WINDSOR)
• RC is defective.
• 8V missing.
• Black vertical bar. on the left.
• Does not start up. Standby LED is present at switch-on. LED becomes green for one sec., then it switches off. (WD36SB WINDSOR repair tip)
• No start-up. LED is red .
• Picture is instable, horizontal lines from the top to the bottom.
• R809 and R821 smoking after a few minutes.
• Horizontal line.
• Chassis type.
• No start-up from standby. LED is red . No line drive.
• No functions.
• Vertical streaks.
• Q602 trips repeatedly.
• No start-up from standby.
• Dead (intermittently).
• No function via 12/24V power supply.
• Unstable picture.
• Intermittently switches off and goes to standby. If switched on again, a digit key has to be pressed on RC.
• Slow start-up.
• Enter service mode.
• Blue screen.
• Dead.
• Blue picture. Retrace lines.
• No funciona. LED en rojo
• Green picture. Flyback lines.
• Appliance stuck in BG mode.
• No horizontal or vertical deflection.
• 2-3 cm horizontal stripe in the middle of screen.
• HV output stage (BU808DFI) defective.
• Tripping.