KXH3E / YASHICA [Camcorder - 8mm]

• Damaged cabinet. Loosened grip belt.
• In playback picture is broken from top to bottom. Vertical trembling of a part of the picture.
• Mechanism loads halfway without cassette, rewinds a few seconds and stops.
• Physical damage. The jack cover detaches from the in/out terminal.
• Unit will not close door. When applying power, mechanism ejects OK, but will not set back to load/unload state.
• When in REW, drum reverses. When loading the drum slows down, then the tape is unloaded.
• Mechanical noise. Mechanical noise during rew, or noise captured during REC.
• No tape loading, loads ok without a tape. No drum rotation.
• No Eject. Caution LED flashing. E-E OK.
• Loads tape then ejects immediately.
• Bright points in pixel. 1-CCD defective pixel repair.
• No eject.
• Does not accept tape.
• TG1 arm falls out.
• No eject. Other functions OK .
• Service information. Wiping cloth for video heads and drum.
• Camera switches off again immediately since the supply table is not driven.
• Doesn't load cassette. Creaking noise from the mechanism.
• Blocks intermittently during tape unloading.
• Does not load tape. intermittently.
• Closes and starts to load, then jams.
• Automatic focus and zoom fail intermittently.
• Does not accept tape. Closes OK without one.
• Picture quality problem. Black inversion phenomenon may occur when using a Hi8ME tape which has been recorded in lp mode.
• Does not load tape. No drum/head rotation.
• Tape stuck in mechanism, no functions. Loads OK.
• Cassette ejects but new cassette cannot be inserted.
• The take up reel table does not rotate with an inserted cassette.
• Eats tape.
• RK gear goes under supply reel in REW and breaks.
• Damaged CRT or viewfinder. The EVF cabinet surrounding the CRT is damaged. The damage is patches of plastic having been affected by surface heat.
• Unit loads half way. Drum fails to change direction, then unit unloads.
• Mechanical noise. Mechanical noise during rew, or noise captured during REC.
• Will not load tapes (intermittently no rewind). Mechanism only half loads then slowly attempts to finish.
• Failure of flexible membrane may result in various faults.
• Service information. Adjustment procedure for steady shot function.
• Irregular loading. The cass tape may stick to the drum resulting in the tape being ejected. (last emergency - drum pg error).
• No mechanical operation. The bulletin illustrates a procedure to be followed to determine if the T reel and S reel need replacement.
• Unsynchronised and unrecognizable video signal in Cam.-E mode and cass. PB. (YASHICA - KXH3E information)
• ATF servo fails during PB.
• Cassette stuck in appliance and "caution" warning is displayed.
• Intermittent transport.
• Does not load tape. No eject. Fault occurs intermittently. .
• Cassette compartment will not release.
• No functions.
• Display function problem. Data code indication may shift one character to right. The 12 hour format of the clock may change to 24 hour format. (+ extract of circuit diagram)
• Unstable picture. Oil on the tape or on the tape path may cause picture distortion, head clogging, tape eject or no drum rotation.
• Mechanism jammed. intermittently.
• Motor noise. Drum motor noise may be recorded by the microphone.
• Board compatibility. New board types are supplied as replacement parts.
• No eject intermittently. Capstan motor possibly doesn't rotate. Intermittently ejects. Capstan motor not rotating.
• During playback alternating dark/bright vertical bars appear on picture. The symptom is most obvious on dark passages.
• Intermittently does not accept tape.
• No unloading or ejecting of tape.. Although the unloading operation during eject is normal the cassette compartment does not rise.
• Extension cable J-13 info.
• Eject inop ( TG-1 lever comes off it's guide ) (KXH3E YASHICA repair tip)
• Service information. The a/D converter (for zooming) has been changed.
• Service information. The CCDTR805E is equipped with the guide rail base (1) assy P/N A7040251F.
• Drum runs at high speed when power is applied.
• Switches off after a short time. Take-up reel jolts. (YASHICA - KXH3E information)
• Cassette compartment won't rise (YASHICA - KXH3E information)
• Door will not close.
• The plastics which surround the CRT may be melted by the sunlight.
• Switches continuously from SP to LP.
• Does not load tape.
• Pixel repair for LANCLink Interface.
• Mechanical noise in REW, PB and REC.
• Misindication of data code and time. When switching from REC to STOP while the time is indicated on the data code display, the 12-hour format on the EVF or the LCD may change to the 24-hour format (e.g. 15:00 PM instead of 3:00 PM). (part of circuit diagram displayed)
• Intermittently dead. (extract of circuit diagram attached)
• No mechanical operation. The bulletin illustrates a procedure to be followed to determine if the T reel and S reel need replacement.
• After a short time no camera picture. Picture shakes or fails.
• VCR skew problem in certain mode. Skew may occur at the noise bar during CUE/REV or pause.
• With some ME tapes, the data code may not show, and the indication "--:--:.." may appear instead.
• Tape spills out when REW is selected. (YASHICA - KXH3E information)
• Broken focus ring, zoom OK.
• Speed problem. T guide arm and rail base guide replacement procedure.
• Wavy representation of vertical lines.
• Tape jams.
• Data screen shifts horizontally during PB.
• Caution light on when loading.
• Service manual amendment. Flange back adjustment. (KXH3E tips)
• Noisy audio. A rustling sound or sound interruptions may occur when using mp tapes. (with circuit diagram extract)
• Misindication of data code and time. During playback the data code indication may shift one character to the right. (with circuit diagram extract)
• Faulty data communication. No SP/lp distinction in playback.
• Picture displaced horizontally in zones. Looks like a drop out fault. Drop outs visible in envelope curve.
• Mechanical noise. (KXH3E YASHICA repair tip)
• Snow in picture in Camera mode. Disappears after functioning for a while.
• No eject. Powers down with caution indicator blinking.
• Does not accept cassette. Mechanical crunching noise.
• Ejection of cassettes is defective, blocked mechanically. (KXH3E tip from YASHICA)
• Ticking noise from mechanism in all modes.
• Destroys under side of tape.
• Transport noise in FF, REW and PB.